Panasonic TH-65SF2U Operating Instructions Manual

Also see for TH-43SF2E: Operating Instructions - Basic Guide

Contents

Panasonic TH-65SF2U Operating Instructions Manual Manual pdf 59 page image

59EnglishNetwork settingsSet when networking with a computer.[Network settings] submenu will be displayed.Network settingsSerial controlSF2-000OffSERIAL INOffOffDisplay nameDIGITAL LINK statusDIGITAL LINK menuNetwork statusLAN setupAMX D. D.Extron XTPCrestron Connected™ResetOffAuto display namePermitUSB memory network settingsDIGITAL LINK mode AutoNetwork control Off■ [Serial control](TH-65SF2E only)Selects the RS232-C control terminal.[SERIAL IN]:Controls using the SERIAL IN terminal of thedisplay.[DIGITAL LINK]:Controls via the optional device that supportsDIGITAL LINK output (ET-YFB100G, ET-YFB200G) and the DIGITAL LINK / LAN terminal.■ [Network control]Set when controlling with the unit’s LAN terminal.[On]:Controls via LAN using the LAN terminal of theDisplay. The power indicator lights orange whenthe power is turned off with the remote control(standby).[Off]:Invalidates control with LAN terminal.(In this case, the power consumption of Standbycondition (when the power is turned off with theremote control) will be slightly reduced.)Note● When using the LAN control function for “UsingNetwork Function” (see page 78 ‒ 93), set thisfunction to [On]. Even if [Off] is selected, the HDMIcommunication via a twisted pair cable transmitteris possible while the power is on.■ [Auto display name]Sets whether to change the display nameautomatically.[On]:Changes the display name automatically inaccordance with the set point of the display ID.[Off]:The display name is not changed automatically.■ [Display name]The name of the Display that is shown on the networkcan be changed.Note● The name can be changed only when [Auto displayname] is set to [Off].● Display ID is not reset to default with [Networksettings] - [Reset].■ [LAN setup]Detailed network settings for the LAN established viathe LAN terminal of the Display can be configured.Select [LAN setup] with and press .192.168. 0. 8255.255.255. 0192.168. 0. 1102412:34:56:78:9A:BCLAN setupSaveDHCP OffIP addressSubnet maskGatewayPortMAC address[DHCP], [IP address], [Subnet mask], [Gateway]Press to set [On] / [Off] of [DHCP].When [Off] is selected, IP address and other settingscan be set manually.[DHCP]:(DHCP client function)[On]:Obtains an IP address automatically when aDHCP server exists in the network the Display isgoing to be connected.[Off]:When a DHCP server does not exist in thenetwork the Display is going to be connected,set [IP address], [Subnet mask] and [Gateway]manually.[IP address]:(IP address display and setting)Enter an IP address when DHCP server is notused.[Subnet mask]:(Subnet mask display and setting)Enter a Subnet mask when DHCP server is notused.