Panasonic TH-65SF2U Operating Instructions Manual

Also see for TH-43SF2E: Operating Instructions - Basic Guide

Contents

Panasonic TH-65SF2U Operating Instructions Manual Manual pdf 114 page image

English114USB memorynetwork settingsUsing a USB memory device, the network setting can bemade for multiple displays.■ About the settingThe following items in [Network settings] - [LANsetup] can be set.[IP address], [Subnet mask], [Gateway], [Port]Note● [Network settings] - [LAN setup] - [DHCP] is set to[Off].● [Network settings] - [Network control] is set to [On].● Make sure that [Network settings] - [USB memorynetwork settings] is set to [Permit].If it is set to [Prohibit], network setting cannot bemade with this function. (see page 62)● Once the network setting is done with USB memorydevice, [Network settings] - [USB memory networksettings] is set to [Prohibit].■ Supported device● Commercially available USB memory devices aresupported. (Those with security functions are notsupported. Operation is not guaranteed.)● USB memory devices other than those formatted inFAT16 or FAT32 cannot be used.● Up to 32 GB of USB memory in size are supported.● Only single partition configuration is supported.● Use a writable USB memory device.Saving the LAN setting file to theUSB memory deviceCreate the following files, and save them to the USBmemory device.File name: th-65sf2_network.shSetting ExampleTH-65SF2_LAN_SETTINGSA:192.168.0.18S:255.255.255.0G:192.168.0.1P:1024I:ONTH-65SF2_LAN_SETTINGS:Fixed characters represent the model name. Be sure toinput as follows.TH-(inch size)(Model name)_LAN_SETTINGSA: Specifies the IP address.S: Specifies the subnet maskG: Specifies the gateway addressP: Specifies the port numberI: Setting this to [ON] can set individual IP addresses foreach main unit.One IP address is assigned to each main unit in therange that can be specified as an IP address.Note● Deleting the rows S, G, P and I will not overwrite thedeleted setting items. The original setting contentsare retained.● Be sure to fill in the rows of the fixed character andIP address.● If the network setting fails with this function, an errormessage is displayed.If fails, the network setting is not changed.Be sure to confirm the file description, and insert theUSB memory device again.● This function operates only when a file with the abovefile name exists in the USB memory device.● Use one-byte alphanumeric characters to describefile contents.Copying the USB memory data to thedisplay1 Insert the USB memory device to theUSB terminal at the bottom of thedisplay.USB memoryUSB terminal2 The [LAN setup] screen is displayedafter data copy has finished.3 Remove the USB memory device fromthe USB terminal.