NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 47 page image

E – 40Source InformationDisplays the status of the current signal. This dialog box has three pages.Projector InformationDisplays the information for your projector such as lamp usage, serialnumber and version number etc..[Page 4]Link ModeDisplaying Current Status of Link ModeWhen selecting the tab "Page 4 ", you will get the following dialogbox.Master ID .................... Indicates the Master projectorStatus ......................... Indicates the status of the master projectorConnected PJ .............. Indicates number of connected slave projectorsSlave No ..................... Indicates serial number of the slave projectorID ................................ Indicates ID of a slave projectorStatus ......................... Indicates the status of the slave projectorPage buttons ....... Turns pages. One screen displays information of 3projectors only. Information of a maximum of 16projectors can be displayed using these page but-tons.Reconnect button ....... Confirms connection of all linked projectorsStatus items:Running ...................... The projector is now workingCooling Lamp ............. The fan is now cooling the lampStandby ...................... The projector is in stand-byCommunication Error . A communication error has occurredConnecting .................. The projector is now verifying for connectionError Standby ............. An error caused the projector to enter the stand-bymode.Test PatternPress to display the test pattern. Pressing this button sequentially se-lects five test patterns.Selecting a new signal that is close to one of thelisted signals in horizontal and vertical frequencySelecting a new signal that is close to one of the listed signals in hori-zontal and vertical frequency may not display the image correctly be-cause the new signal is considered as one of the registered signalslisted in the Entry List. (In this case the Auto Adjust feature may notwork correctly.)To use both signals, use different input terminal (RGB 1, RGB 2 or RGB3) respectively, or assign specific remote keys for signals.1. Cut an existing signal from the Entry List.1) Select another signal other than the one currently projected because thecurrently projected signal cannot be cut.2) Press the ENTRY LIST button on the supplied remote control.3) After selecting the existing signal, press and hold down the CTL buttonand then the ENTER button simultaneously on the remote control. TheEntry Edit Command window will appear. Select "Cut" and press the ENTERbutton.The selected signal will be deleted from the Entry List. (The signal data isstored in the clipboard.)2. Select the new signal and enter it in the Entry List.Press and hold down the CTL button and then press the ENTRYLIST button simultaneously on the supplied remote control to enterthe signal in the Entry List.3. Paste the signal data that was cut and placed in the clipboard in Step1.1) Select a vacant line in the Entry List.2) Press and hold down the CTL and then ENTER buttons simultaneously todisplay the Entry Edit Command window.3) Select "Paste" and press the ENTER button on the remote control to addthe signal to the Entry List.4. Assign the listed signals for direct keys respectively.1) Select the one signal in the Entry List, and press and hold down the CTLand the ENTER buttons simultaneously on the remote control to displaythe Entry Edit Command window.2) Select "Edit" and then press the ENTER button to display the Entry Editscreen3) Select "Direct Key" and press the ENTER button to display the Direct Keyscreen.4) Assign the signals for direct keys.NOTE: Be sure not to disconnect the power cable while you are performingstep 1 to 3. Failure to do so will delete the signal data stored in the clipboard.See also pages E-31 and E-32 for Entry List.