NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 29 page image

E – 22When used in stand alone operation.Pin No.145104,8,12,11SHORT/OPENSHORTOPENSHORTOPENSHORTOPENFUNCTIONExternal control mode ONExternal control mode OFFPOWER ONPOWER OFFPICTURE MUTE ONPICTURE MUTE OFF* When the combinations other than specified in the above table are selected, the input will be forcefully switched to RGB 1.* The term “SHORT” means to connect with pin 15* When in the external control mode, the POWER, INPUT, PICTURE MUTE and SOUND MUTE buttons on the remote control will not function.NOTE: Pin 13 is the external remote signal terminal. The projector can be controlled by the same format signal as the supplied remote control from the externalcontroller regardless of setting on Pin 14.NOTE: When turning off the power to the projector using the external control, do not disconnect the plug from the power outlet. These procedures are to protect yourprojector and the connected equipment.11pinOPENOPENOPENOPENOPENOPENOPENOPENSHORTSHORT12pinOPENOPENOPENOPENSHORTSHORTSHORTSHORTOPENOPEN8pinOPENOPENSHORTSHORTOPENOPENSHORTSHORTOPENSHORT4pinOPENSHORTOPENSHORTOPENSHORTOPENSHORTOPENOPENRGB 1 (INPUT 1)VIDEO 1 (INPUT 5)S-VIDEO 1 (INPUT 7)COMPONENT (INPUT 4)SDI (INPUT 0)RGB 2 (INPUT 2)VIDEO 2 (INPUT 6)S-VIDEO 2 (INPUT 8)RGB (DIGITAL) (INPUT 9)RGB 3 (INPUT 3)