NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 30 page image

E – 23REMOTE2INPUT7S-VIDEO1YCINOUTOperating Multiple Projectors with Remote ControlYou can operate multiple projectors with the same remote control in wireless operation.To do so:1. Select [Menu] → [Projector Options] → [Setup] → [Page 5] → [Projector ID] and assign an ID number to each projector. See also page E-39.2. On the remote control specify the ID number of the projector to be adjusted. Press and hold the CTL and press MENU (ADDRESS) button toenter the ID number.You can operate the projector assigned the same ID number as the remote control.Projector ID= 01 Projector ID= 02 Projector ID= 03Remote Address = 03You can daisy-chain multiple projectors and operate them separately with the same remote control in wired operation.To do so:1. Use the remote control cable to connect the REMOTE 2 Output of one projector to the REMOTE 2 Input of the next projector until all the projectors areconnected. Only one remote control cable is supplied with each projector.2. Specify a unique projector ID for each projector.3. Specify the same remote address as the projector ID to be adjusted.NOTE: Specifying "None" for projector ID allows you to operate multiple projectors concurrently. However, some projectors may not synchronize to the otherprojectors.Projector ID= 01 Projector ID= 02 Projector ID= 03Remote Address = 03