NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 25 page image

E – 18INPUT3RGB R/CrG/YB/CbH/HVVR/Cr CrYG/YB/Cb CbH/HVVOPTIONINOUTREMOTE1REMOTE2INPUT7 INPUT8INPUT5S-VIDEO1YCS-VIDEO2VIDEO1 VIDEO2INPUT6INOUTINPUT2 INPUT1 INPUT4When Used with One Switcher (ISS-6020/ISS-6020G)Up to 10 input signals can be accepted when the projector is connected to one Switcher. Using the projector with the Switcher allows easyadjustment and signal selection.• Select [Advanced Menu] → [Projector Options] → [Switcher Control] → [SW1 Level]. See page E-39 for the information in detail.• For more information on the Switcher, refer to the user's manual accompanying the ISS-6020/ISS-6020G Switcher.• All cables mentioned above are sold separately.• The RGB2 terminal will not work with the Switcher Control function.* When connecting with the VIDEO INPUT MODULE (6020-VID), set the VIDEO MODE select switch (S3001) to "8". The VIDEO MODE selectswitch is located on the VIDEO INPUT MODULE (6020-VID).NOTE: While in the Switcher Control mode, a video standard is selected at the projector.If you set the VIDEO MODE select switch (S3001) to "8" with the QUAD DECODER installed in the Switcher ISS-6020, the image will not be displayed correctly.In that case, first remove the QUAD DECODER from the Switcher ISS-6020.For more details, contact your dealer.The SwitcherISS-6020/ISS-6020GPersonal computerVCRFrom R, G, B, H/V on separate Hand V. on the RGB OUTPUT moduleTo REMOTE1To SYSTEM CONTROLREMOTE 1Optional control cable 15p-15p(CTL-6010)To INPUT 13BNC-3BNC cable(sync on green)4BNC-4BNC cable(composite)5BNC-5BNC coaxial cable(separate sync)(recommended)