NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 46 page image

E – 39Keystone SaveThis option enables you to save your current keystone settings.Saving your change once affects all sources. The changes are savedwhen you turn off the projector.Doubler (Video / S-Video Only)This sets double speed interpolation of the video signal.On ................ Non-interlaced displayOff ................ Interlaced displayNOTE: The setting will take effect from the next video signal display.Lens MemoryThis function applies the stored lens shift, focus, and zoom adjust-ment values to the selected signal.The function performs a setting that enables or disables the "Adjust(Source)" - "Lens Memory" functions of the menu.• On -- Enables the lens memory function and apply the stored shift, focus,and zoom setting values to the selected signal.• Off -- Disables the lens memory function so that there will be no applica-tion of stored shift, focus, and zoom setting values.NOTE: The shift, focus, and zoom adjustment values can be stored regard-less of whether or not the lens memory function is enabled.NOTE: In the Link mode the Lens Memory feature is not available.User NameType in your desired name using the INPUT buttons on the remotecontrol.Select one character at a time with the INPUT buttons 1 through10(0) and by moving the cursor with the SELECT button. The username must be 18 characters or less.Only after completely finishing the selection of the characters, pressENTER.[Page 5]Communication Speed:This feature sets the baud rate of the PC CONTROL connector (MiniD-Sub 9 Pin).It supports data rates from 4800 to 38400 bps.The default is 38400 bps. Select the appropriate baud rate for yourequipment to be connected.Projector ID:Each projector needs its own unique addresses when used in serialcommunication mode. You can choose one of 64 unique addressusing the spin box. First select Enable. Keep pressing increases thenumber.To make your setting available, select OK.Default Source SelectYou can set the projector to default to any one of its inputs each timethe projector is turned on.Last .............. Sets the projector to default to the previous or last active in-put each time the projector is turned on.Select ........... Displays the selected source input every time the projector isstarted up. Select an input from the pull-down menu.Link ModeThis feature is used for multiple projector connection using RGBDigital Input/Output connectors. The master projector is set to Master.The other slave projectors are set to Slave. When not using Link mode,set to Standalone. See page E-14 for setting up for double stacking inlink mode.Switcher ControlThis feature sets the projector in communication with the NEC ISS-6020 Switchers.Stand Alone ................ Use the projector in stand alone operation.SW 1 Level .................. Use the projector with one Switcher. (not availablein Link mode)SW 2 Level .................. Use the projector with two or more Switchers. (notavailable in Link mode)When changing this setting, the confirmation message will appear. Ifyou want to restart your projector, select Yes; if not, select No.NOTE: This setting becomes effective only after the projector is restarted.HelpContentsProvides an online help about how to use the menus. An underlined linkmeans that you can move to an adjustment item directly.Selecting the underlined link and pressing ENTER moves to the corre-sponding adjustment item.NOTE: The Help Menu may not be displayed correctly when a UXGA signal isdisplayed.