NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 26 page image

E – 19When Used with Two or More Switchers(100 Inputs)Up to 100 inputs can be accepted using the NEC ISS-6020 Switcher.How to make connections:1. Connect the REMOTE 1 terminal of the master Switcher to the RE-MOTE 1 of the projector using the optional control cable (15p-15p/CTL-6010).2. Next connect the REMOTE 2 terminal of the master Switcher to theREMOTE 1 terminal of the first slave Switcher using the same op-tional control cable as mentioned above. Third, connect the REMOTE2 terminal of the first slave to the REMOTE 1 of the second slave,and the REMOTE 2 terminal of the second slave to the REMOTE 1terminal of the third slave (— and the REMOTE 2 of the ninth slave tothe REMOTE 1 of the tenth slave). Connect all the Switchers withoptional control cables.NOTE:• Be sure to set all the slide switches (S8603) of the Switcher to RS-422 posi-tions. Set the one on the last slave Switcher to the appropriate position tomatch the connected equipment such as a personal computer. (RS-422/RS-232C for PC control of projector)• Set the DIP switch S8601 of the Switcher.OPTION (PC)MASTERSWITCHERREMOTECONTROLOPTION(PC)SLAVE 1SLAVE 2SLAVE 1010 inputs10 inputs10 inputsSignal SwitcherSignalREMOTE 1REMOTE 2SignalREMOTE 1REMOTE 2SLAVE 3SLAVE 9 SignalREMOTE 1REMOTE 2REMOTE 2To SLOT 1To SLOT 2To SLOT 10To REMOTE 2REMOTE 1Signal (Input 1)REMOTEProjectorNOTE: The optional remote control RC-6320 for ISS-6020 will not work cor-rectly in the SW Level 1 or 2 mode.REMOTE 1To use the projector with the Switcher ISS-6020 in the Switcher Control mode,* When connecting with the VIDEO INPUT MODULE (6020-VID), set the VIDEO MODE select switch (S3001) to "8". The VIDEO MODE selectswitch is located on the VIDEO INPUT MODULE (6020-VID).NOTE: While in the Switcher Control mode, a video standard is selected at the projector.If you set the VIDEO MODE select switch (S3001) to "8" with the QUAD DECODER installed in the Switcher ISS-6020, the image will not be displayed correctly.In that case, first remove the QUAD DECODER from the Switcher ISS-6020.For more details, contact your dealer.