NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 11 page image

E – 4INPUT3RGB R/CrG/YB/CbH/HVVR/Cr CrYG/YB/Cb CbH/HVVOPTIONINOUTREMOTE1REMOTE2INPUT7 INPUT8INPUT5S-VIDEO1YCS-VIDEO2VIDEO1 VIDEO2INPUT6INOUTINPUT2 INPUT1 INPUT45 612349 10871. INPUT 3 RGB Connector (Mini D-Sub 15 pin)Connect your PC or other analog RGB equipment such as a high-defi-nition document camera.2. Option Connector (Mini D-Sub 9 pin)For system expansion such as PC-control.IN ................. connect to the external equipment such as PC.OUT ............. for daisy-chaining multiple projectors and operating them withthe same external equipment. To do so, connect to a secondprojector's IN terminal to relay the input at the IN terminal ofthe first projector until all the projectors are connected.3. REMOTE 1 Connector (Mini D-Sub 15 pin)This terminal allows external control of the projector from either theSwitcher or from an external control. When the Switcher is used, con-nect to the REMOTE 1 terminal on the back of the Switcher.NOTE: This projector is compatible with the ISS-6020 Switcher.4. REMOTE 2 JacksIN ................. wired remote control input.OUT ............. for daisy-chaining multiple projectors and operating them withthe same remote control. To do so, connect to a second pro-jector' s IN terminal to relay the input at the IN terminal of thefirst projector until all the projectors are connected.5. INPUT 1 and INPUT 2 Terminals (BNC)Connect R,G,B,H (Horizontal sync) and V (Vertical sync) outputs of theexternal equipment such as the Switcher. If using a component with acombined sync (SYNC) output, connect it to the H/V terminal.Also connect component video outputs (Y/Cb/Cr) of the external equip-ment such as DVD player.NOTE: The INPUT 2 terminal does not support SW1 Level and SW2 Level modesfor the ISS-6020 switcher.6. INPUT 4 Cr/Y/Cb Terminal (RCA)Connect component video outputs (Y,Cb,Cr / Y,Pb,Pr) of the externalequipment such as DVD player.NOTE: This terminal accepts component signal only.7. INPUT 5 VIDEO 1 Terminal (BNC)Connect to the BNC video output of the external equipment such as aVCR or laser disk player.8. INPUT 6 VIDEO 2 Terminal (RCA)Connect to the RCA video output of the external equipment such as aVCR or laser disk player.9. INPUT 7 S-VIDEO 1 Terminal (BNC)Connect to the Y/C separate BNC video outputs of the external equip-ment such as a VCR or laser disk player.10. INPUT 8 S-VIDEO 2 Terminal (Mini DIN 4 pin)Connect to the S-video output of the external equipment such as aVCR with an S-video output. This terminal allows switching between S2and S1 VIDEO input modes. See the "S-Video Mode Select" section onpage E-38 for more information.Terminal Panel