NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 40 page image

E – 33Horizontal/Vertical Position (when Auto Adjust is off):Adjusts the image location from left to right.This adjustment is made automatically when the Auto Adjust is turnedon.Aspect Ratio (not available for RGB) :You can select the aspect ratio for input signal and display area re-spectively.Select the appropriate aspect ratio using the SELECT , , , or button.NOTE: When "Resolution" is set to "Native", this feature is not available, andthe stored settings and adjustments are invalid.Resolution (when Auto Adjust is off):This allows you to activate or deactivate the Advanced AccuBlendfeature.Auto ............. Turns on the Advanced AccuBlend feature. The projector au-tomatically reduces or enlarges the current image to fit thefull screen.Native ........... Turns off the Advanced AccuBlend feature. The projector dis-plays the current image in its true resolution. See "Auto Ad-just (RGB Only)" on page E-38 for turning on or off the AutoAdjust feature.NOTE: While you are displaying an image with higher resolution than theprojector's native resolution(SXGA:1280 x 1024), even when you are in theNative mode, the image is displayed full screen using the Advanced AccuBlendfeature.NOTE: The image with lower resolution than SXGA(1280 x 1024) is dis-played in small when you are in the Native. In this case, you can use the lensshift, zoom and focus adjustments, which you saved in advance with "Cus-tom" of "Lens Memory", to enlarge the image to fit on the screen.OverscanYou can select overscan percentage for RGB signal.Select the appropriate option using the SELECT or button.NOTE: When "Resolution" is set to "Native", this feature is not available, andthe stored settings and adjustments are invalid.Video FilterThis feature reduces video noise. Select the appropriate filter foryour signal.Bar 0 ............ OffBar 1/3 ......... HighBar 2/3 ......... MediumBar full ......... LowBlankingThis feature allows you to mask any unwanted area of the screenimage.Blanking On/Off:This setting enables or disables the blanking function.On ................ Blanking function is enabled.Off ................ Blanking function is disabled.* Adjustment of vertical display rangeAdjust the Top or Bottom blanking with the SELECT or button.Video AdjNoise ReductionSelect one of the following three levels for reducing video noise.Low, Medium or High.NOTE: The lower the Noise Reduction level, the better the image quality.Increasing Noise Reduction lowers video bandwidth.