NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 38 page image

E – 31Menu Descriptions & FunctionsSource SelectEnables you to select a video source such as a VCR, DVD player, laserdisc player, computer or document camera depending on what isconnected to your inputs.Press the up/down buttons on your remote control or the projector cabi-net to highlight the menu for the item you want to adjust.* RGB1,2,3* Component (YCbCr)* Video 1, 2* S-Video 1, 2* RGB (Digital)* SDISwicherYou can select the slot number from 1 to 10 of the Switcher(s) ISS-6020.When using with a single Switcher ISS-6020:Use the SELECT or button to select the desired slot number from1 to 10 of the ISS-6020 Swicher and press ENTER.When using with two or more Switcher ISS-6020:Use the SELECT or button to select the master slot number from1 to 10 and then the slave slot number from 1 to 10 on the Select Slotmenu. Select OK and press ENTER.To close the window without storing the settings, select Cancel andpress ENTER.Entry ListDisplays the list of the entry signals. Use the buttons on your re-mote control or the projector cabinet to select the signal and press theENTER button on the remote control or the projector cabinet to projectthe image of the selected source.* Cut Enables you to remove a selected signal from the list and placeit on the "clipboard" in the projector.* Copy Enables you to copy a selected signal from the list and place iton the "clipboard" in the projector.* Paste Enables you to paste the signal placed on the "clipboard" toany other line of the list. To do this, select "Paste" and then select theline number you want to paste to. Last press ENTER.* Edit Enables you to change source name or assign the direct key.* The following buttons are not available for the currently projectingsignals:1) The Cut and Paste buttons on the Entry Edit Command screen2) The Input Terminal button on the Entry Edit screenWhen complete, select OK and press ENTER. To exit without stor-ing setting, select Cancel.Select "Source Name" and press ENTER to display the Source NameEdit window. You can change source name on this window.Select "Input Terminal" and press ENTER to display the Input Termi-nal window. You can change input terminal on this window.RGB1, RGB2, RGB3, and RGB(DIGITAL) can be selected for RGBsignals; RGB1, RGB2, Component, and RGB(DIGITAL) can be se-lected for component signals; Video 1/2, S-Video 1/2 , andRGB(DIGITAL) can be selected for Video and S-Video signals.Select "Direct Key" and press ENTER to display the Direct Key win-dow.You can assign specific remote keys for direct signal input selection.NOTE: Existing direct key settings are overwritten with new settings.Entry Edit CommandYou can edit the signal on the entry list.To do so:1. While pressing and holding CTL, press ENTER on the remote control todisplay the Entry Edit Command window.