NEC MultiSync SX4000 User Manual

Contents

NEC MultiSync SX4000 User Manual Manual pdf 41 page image

E – 34Color MatrixFirst, select an appropriate color matrix for your input signal, eitherHDTV or SDTV. Then select an appropriate matrix type from B-Y/R-Y, Cb/Cr, Pb/Pr or IVX.NOTE: The Color Matrix feature is available for component video signal only.Y/C Delay (not available for RGB)Adjusts Y/C delay level.TelecineUse 3:2 pull down correction to eliminate jitter and artifacts in video.Auto ............. For film source such as a DVD playerOff ................ For signals other than film sourcesMotion Select:Sets the interpolation method. Selects Still or Adaptive. Still is usedfor non moving images such as a document camera. Select Adapterfor all motion video.Motion LevelAdjusts level of motion detection when Adaptive is selected.YTR Adjustmen (not available for RGB)Adjusts luminance transient time.CTR Adjustment (not available for RGB)Adjusts chroma transient time.Option AdjAccording to the signal, this function sets the detection position (i.e.,clamp position) of the black level reproduction of the analog inputsignal. Normally this is not used. (1080P is set as the default)Auto ............. This is the normal setting.Tri-Sync ....... This is set when projecting HDTV video.Front Porch .. This is set when the picture quality does not improve eventhough Auto or Tri-Sync has been set.Adjust .......... This permits the video clamp position for each signal to beset. Use "Adjust" when a clamp timing error occurs at the timeof special analog signal reception such as 1080P. Note that"Adjust" is not valid for doubler signals such as NTSC andPAL.To delete the "Clamp Timing" setting screen, select the SELECT button and press the ENTER button, or press the remote controlCANCEL button.Sync ProtectionWhen a VCR, DVD, or some other equipment that supportsCopyguard (a copy prevention system) is played back, the screenmay be displayed in a curved manner. Adjustments are made insuch circumstances. Use the SELECT or button to adjust theVD level.VD DelayThis feature is used to correct vertical jitter of non-standard inter-laced signal.NOTE: When connecting with a scan converter:If an image from the scan converter is not correctly displayed, adjust toselect the best level point so that the image is displayed correctly.Clamp Timing: