Configuring Your System 3-19Table 3-1. SCSISelect Utility Setup Configurations (continued)OPTIONRECOMMENDED SETTINGOR DISPLAY ONLYYOURCONFIGURATIONDisplay Messages During BIOSInitializationEnabledExtended Int13 Translation for DOSDrives >1 GByteEnabledPOST Display Mode VerboseSCSI Controller Int13 Support Enabled 1Domain Validation Enabled 1Support Removable DisksUnder Int13 as Fixed DisksDisabled 1, 2BIOS Support for Bootable CDROM Enabled 1BIOS Support for Bootable CDROM Enabled 11 No effect if BIOS is disabled.2 Do not remove media from a removable media drive if it is under BIOS control.SCSI Disk UtilitiesThis utility scans the SCSI bus for SCSI devices, reports a description of eachdevice. Run these utilities before configuring SCSI devices.To enter the utility, select "SCSI Disk Utilities" on the Options menu.The SCSI ID scan begins displaying the message as shown below.Scanning SCSI ID : 0 LUN Number : 0When the SCSI ID scan completes, the screen listing SCSI IDs and associateddevices appears.Select SCSI Disk and press SCSI ID #0 : No deviceSCSI ID #1 : No deviceSCSI ID #2 : No deviceSCSI ID #3 : No deviceSCSI ID #4 : No deviceSCSI ID #5 : No deviceSCSI ID #6 : No deviceSCSI ID #7 : Adaptec AIC-7899SCSI ID #8 : No deviceSCSI ID #9 : No deviceSCSI ID #10 : No deviceSCSI ID #11 : No deviceSCSI ID #12 : No deviceSCSI ID #13 : No deviceSCSI ID #14 : No deviceSCSI ID #15 : No device
