NEC Express5800/120Rf-2 User Manual

Also see for Express5800/120Rf-2: Product guide Release note

Contents

NEC Express5800/120Rf-2 User Manual Manual pdf 39 page image

Setting Up the System 2-7Installation ProcedurePerform the following procedures to install the server into the rack:Removing the Rail Assemblies1. The rail assemblies may be shipped already mounted to the sides of theserver. Each rail assembly consists of a stationary rail attached to the serverand a removable sliding rail. Following Steps 2 and 3, remove the slidingrails from the server.Note: The removed rail assemblies are to be installed on the innerrails later. To install each rail assembly on the correct inner rail, markeach rail as removed. Similarly, when installing more than one server,distinguish between the pairs of inner rails and rail assemblies of theservers by marking the left and right hand rails.2. Hold the rails and slowly slide them toward the rear of the server until a"click" is heard. The click indicates that the rails are in the locked position.3. Push the release levers on the right and left sides of the rails (Figure 2-2, A),and remove the sliding rail assemblies from the server.AFigure 2-2. Removing the Rail Assemblies from the ServerNote: The inner stationary rails remain screwed to theserver when the rail assemblies have been removed. SeeFigure 2-3.