Setting Up the System 2-31Getting Familiar with the SystemBefore turning on and setting up your system, you should become familiar withthe system’s features, such as the location of your system's front and rear panelswitches, indicators and connectors, etc. This section describes the systemswitches, indicators and connectors.Front View with Front Bezel ClosedFigure 2-35 shows the location of the front system features visible with the frontbezel installed.ID21ABC D E F GA Front bezelThe front bezel is a cover protecting the front devices during daily operation. A security keyis provided to lock the cover.B Key slotInsert the security key into this slot when unlocking the front bezel.C ACT lamp (green)This lamp is on while the system is connected to the network and blinks if there is networkactivity. The number "1" on the icon indicates LAN port 1, and the number "2" indicates LANport 2.D POWER lamp (green)This lamp turns green when the power is turned on.E STATUS lamp (green/amber) (on the front panel)This lamp indicates the server status. The lamp is green during normal operation. The lampturns amber or flashes when the server experiences a fault.F DISK ACCESS lamp (green/amber)This lamp is green during access to the internal hard disks. The lamp turns amber when oneof the internal hard disks fails.G UID lamp (blue)This lamp illuminates when the UID switch is pressed. (The lamp also turns on or blinkswhen software issues a command.)Figure 2-35. Front View Controls and Indicators (Bezel Closed)
