5-20 Problem SolvingBeep CodesIf an error occurs during the POST, the server beeps, indicating the type of error.Each number indicates the number of short beeps, and a hyphen indicates a pause. Forexample, the beep interval 1-5-2-2 indicates 1 beep, pause, 2 beeps, pause, 2 beeps,pause, and 3 beeps notifying that no processor is detected on the system board.Table 5-2. Post Error Beep CodesBeeps Error Recommended Action1 Refresh timer error Contact your service representative to replace the system board2 Parity error3 Base memory failureCheck if the DIMM cards are mounted correctly. If the error stilloccurs when the check result is normal, contact your servicerepresentative to replace the DIMM card or system board.4 System timer error Contact your service representative to replace the systemboard.5 Processor failure Contact your service representative to replace the processor orsystem board.6 Keyboard controllererrorCheck if the keyboard is connected correctly.Contact your service representative to replace the keyboard orsystem board.7 Processor exceptioninterrupt errorContact your service representative to replace the processor orsystem board.8 Display memoryread/write errorContact your service representative to replace the systemboard.9 ROM checksum error10 Shutdown registererror11 BIOS disabledContact your service representative to replace the systemboard.1-5-1-1 FRB failure Contact your service representative to replace the processor orsystem board.1-5-2-1 Processor type error Check if the type of the mounted processor is correct. If theerror still occurs when the check result is normal, contact yourservice representative to replace the processor or systemboard.1-5-2-2 Processor notdetectedCheck if the processor is mounted correctly. If the error stilloccurs when the check result is normal, contact your servicerepresentative to replace the processor or system board.1-5-4-2 Power failure Contact your service representative to replace the power supplyunit, power jumper board, or system board.1-5-4-3 Chip set control error Contact your service representative to replace the systemboard.1-5-4-4 Power control error Contact your service representative to replace the power supplyunit, power jumper board, or system board.
