System Overview 1-3System FeaturesYour system features the following major components:! Single or dual high-performance Intel™ Xeon™ 2.00GHz or 2.80GHzprocessors.! 256 MB to 6 GB of ECC SDRAM two way interleaved memory, using up to sixDIMMs.! Six PCI expansion slots for add-in boards (three full-length, full height 64-bit/100MHz PCI-X riser slots and three low profile 64-bit/100MHz riser slots).! A maximum of seven hot-swap SCSI hard disk drive bays accessible from thefront of the chassis.! Hot-swap SCSI disk drive backplane; a failed drive can be removed and replacedwith a new drive without system power being turned off (if an optionalRedundant Array of Independent Disks (RAID) controller is installed.)! High degree of SCSI disk fault tolerance and advanced disk array managementfeatures through the use of RAID technology, if an optional RAID controller isinstalled.! Embedded PC-compatible support (serial, parallel, mouse, keyboard, diskette,USB, LAN, and video).! Integrated onboard ATI RAGE XL Video Graphics Array (VGA) controller with8MB of video memory (VRAM).! Adaptec AIC-7902W SCSI controller providing dual channel Ultra-320 SCSIinterfaces.! Integrated Network Interface Controller (NIC), a dual channel Intel 82546EBGigabit Ethernet LAN controller supporting 10Base-T/100Base-TX/1000Base-Tnetwork systems.! Dual channel enhanced IDE controller (secondary channel supported only).! One 3.5-inch removable media expansion bays.! IDE 24X CD-ROM drive and 3 ½-inch diskette drive.! Three integrated Universal Serial Bus (USB) ports, one located at the front paneland two located at the rear panel.! Hardware monitors (temperature, fans, and voltage) and software monitors toindicate failures.
