NEC Express5800/120Rf-2 User Manual

Also see for Express5800/120Rf-2: Product guide Release note

Contents

NEC Express5800/120Rf-2 User Manual Manual pdf 82 page image

3-2 Configuring Your SystemConfiguring Your SystemConfiguration and setup utilities are used to change your system configuration.You can configure your system, as well as option boards you may add to yoursystem, using the BIOS Setup Utility. Several unique system parameters areconfigured using the BIOS Setup, which is stored in the system FLASHmemory.The SCSISelect Utility detects the SCSI host adapters on the system board. Usethis utility if you need to configure the two SCSI controllers in your system or toperform a SCSI disk format or verify disk operation on the SCSI disk drives.The Adaptec Configuration Utility is also used to configure any SCSIremovable media devices installed in your system.If your system has been factory configured, the BIOS Setup or SCSISelectUtility do not need to be run unless you want to change the password or securityfeatures, add certain types of option boards or devices, or upgrade your systemboard.This chapter also provides information on several system configurationparameters that are set by jumpers on the system board. However, theseparameters do not usually require change.Use the E XPRESS BUILDER CD-ROM to create the device driver diskettes.