5-12 Problem SolvingDiskette Drive Activity LED Does Not LightCheck the following:! Is the diskette drive properly configured?! Is the CDROM/Floppy Disk Drive combo properly installed in the flex bay?Use BIOS Setup to make sure that the diskette drive controller is set to Enabled. Forinformation about running BIOS Setup, refer to the Configuring Your System chapter.If the problem persists, there may be a problem with the diskette drive, system board, ordrive signal cable. Contact your service representative for assistance.CD-ROM Drive Activity Light Does Not LightCheck the following:! Is the CDROM/Floppy Disk Drive combo properly installed in the flex bay?! Are all relevant switches and jumpers on the drive set correctly?! Is the drive properly configured?! Is the onboard IDE controller enabled?Problems with Application SoftwareIf you have problems with application software, perform the following:! Verify that the software is properly configured for the system. Refer to the softwareinstallation and operation documentation for instructions on setting up and using thesoftware.! Verify a different copy of the software to see if the problem is with the copy that youare using.! Make sure all cables are installed correctly.! Verify that the system board jumpers are set correctly. Refer to the Configuring YourSystem chapter for jumper settings.! If other software runs correctly on the system, contact your vendor about the failingsoftware.If the problem persists, contact the software vendor's customer service representativefor assistance.
