Lenovo ThinkSystem SD650 Manual

Also see for 5468: Setup guide Quick start

Need thermal team input• FQXSPPU0002G: The Processor [ProcessorElementName] is operating in a Degraded State.This message is for the use case when an implementation has detected a Processor is running in theDegraded state.Severity: WarningServiceable: YesAutomatically notify Support: NoAlert Category: Warning - CPUSNMP Trap ID: 42CIM Prefix: PLAT CIM ID: 0038User Action:1. Please check power status.2. Turn off the existing application that you are running and wait for 10 mins to monitor the device beback to normal.3. If the problem still exist, please reboot the system.4. Contact local service to solve the issue if the probme still exist.• FQXSPPU0003N: [ProcessorElementName] has Failed with IERR.This message is for the use case when an implementation has detected a Processor Failed - IERRCondition.Severity: ErrorServiceable: YesAutomatically notify Support: NoAlert Category: Critical - CPUSNMP Trap ID: 40CIM Prefix: PLAT CIM ID: 0042User Action:1. Please collect system event log to repository device or deive to save for local service to investigate.2. Please reboot the system.(AC off )3. If the problem still exist, please provide the saved data to local serivce.• FQXSPPU2000I: [ProcessorElementName] in slot [SlotElementName] has been removed.This message is for the use case when an implementation has detected a Processor has been Removed.Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22CIM Prefix: PLAT CIM ID: 0035User Action:Information only; no action is required• FQXSPPU2001I: An Over-Temperature Condition has been removed on [ProcessorElementName].This message is for the use case when an implementation has detected a Over-Temperature Conditionhas been Removed for Processor.90 ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Messages and Codes Reference