Lenovo ThinkSystem SD650 Manual

Also see for 5468: Setup guide Quick start

Information only; no action is required.• FQXSFMA0008M: DIMM [arg1] has failed the POST memory test. [arg2]Severity: ErrorParameters:[arg1]: DIMM slot silklabel [arg2]: DIMM identifier consists of S/N, FRU and UDI, e.g. "739E68ED-VC10FRU 0123456"User Action:Complete the following steps:1. If the DIMM configuration was changed prior to this failure verify that the DIMMs are installed in thecorrect population sequence.2. RESEAT the DIMM that failed POST memory test and the DIMMs on adjacent slots if populated. Bootto F1 setup and enable the DIMM. Reboot the system.3. Swap the DIMM from failure location to another known good location to see if the failure follow theDIMM or DIMM slot.4. If this problem was encountered during an XCC / UEFI update process:a. Power cycle the system by removing power for a few seconds.b. Clear CMOS settings by removing battery for a few seconds.5. If the problem persists, collect Service Data logs and contact Lenovo Support.• FQXSFMA0009I: Invalid memory configuration for Mirror Mode has been recovered. [arg1]Severity: InfoParameters:[arg1]: DIMM identifier consists of S/N, FRU and UDI, e.g. "739E68ED-VC10 FRU 0123456"User Action:Information only; no action is required.• FQXSFMA0009K: Invalid memory configuration for Mirror Mode. Please correct memoryconfiguration. [arg1]Severity: ErrorParameters:[arg1]: DIMM identifier consists of S/N, FRU and UDI, e.g. "739E68ED-VC10 FRU 0123456"User Action:Complete the following steps:1. Ensure that all the DIMMs are enabled and functional by booting to F1 Setup or in XCC web .If anyDIMMs are non-functional adddress that first.2. Make sure that the DIMM connectors are correctly populated for mirroring mode, according to theservice information for this product.3. If the problem persists, collect Service Data logs and contact Lenovo Support.• FQXSFMA0010I: Invalid memory configuration for Sparing Mode has been recovered. [arg1]Severity: InfoParameters:[arg1]: DIMM identifier consists of S/N, FRU and UDI, e.g. "739E68ED-VC10 FRU 0123456"Chapter 3. UEFI events 157