Lenovo ThinkSystem SD650 Manual

Also see for 5468: Setup guide Quick start

User Action:1. Remove A/C from the server and reseat all drives, backplanes, RAID adapters, expanders (if any), andcables.2. Ensure device firmware is at the latest level.3. Retry the test.4. If the problem persists, contact technical support.• FQXPMSD0005M: self-test completed having the servo (and/or seek) test element of the test failed.Severity: ErrorUser Action:1. Remove A/C from the server and reseat all drives, backplanes, RAID adapters, expanders (if any), andcables.2. Ensure device firmware is at the latest level.3. Retry the test.4. If the problem persists, contact technical support.• FQXPMSD0006M: self-test completed having the read element of the test failed.Severity: ErrorUser Action:1. Remove A/C from the server and reseat all drives, backplanes, RAID adapters, expanders (if any), andcables.2. Ensure device firmware is at the latest level.3. Retry the test.4. If the problem persists, contact technical support.• FQXPMSD0007M: Hard Drive(s) not foundSeverity: ErrorUser Action:1. Remove A/C from the server and reseat all drives, backplanes, RAID adapters, expanders (if any), andcables.2. Ensure device firmware is at the latest level.3. Verify that the same Error is present in BMC or OneCLI inventory log.4. Retry the test.5. If the problem persists, contact technical support.• FQXPMSD0008M: UEFI is not ready for LXPM to send command to test hard drive.Severity: ErrorUser Action:1. Reboot system and run the test again.2. If this message is still reported, run the latest version of SMART tool on OS which is open source tooland could be downloaded from website to check hard drive status.3. If the problem persists, contact technical support.• FQXPMSD0009M: Device error detected when LXPM sent a test command to a hard drive.200 ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Messages and Codes Reference