Severity: ErrorParameters:[arg1]: Socket number, 1-based [arg2]: Port Number [arg3]: Socket number, 1-based [arg4]: Port NumberUser Action:Complete the following steps:1. Power off the system and remove A/C power.2. Restore A/C power and power on the system.3. If the problem persists, collect Service Data logs and contact Lenovo Support.Note: The solution for this error may involve a system board replacement. If TPM encryption hasbeen enabled, back up TPM Encryption Recovery Key.• FQXSFIO0007M: An error has been detected by the IIO on Bus [arg1]. The value of Global FatalError Status register is [arg2]. The value of Global Non-Fatal Error Status register is [arg3]. Pleasecheck error logs for additional downstream device error data.Severity: ErrorParameters:[arg1]: Bus [arg2]: Global Fatal Error Status register value [arg3]: Global Non-Fatal Error Status registervalueUser Action:Complete the following steps:1. Check Lenovo Support site for an applicable service bulletin or firmware update for the system oradapter that applies to this error.2. If the problem persists, collect Service Data logs and contact Lenovo Support.Note: The solution for this error may involve a system board replacement. If TPM encryption hasbeen enabled, back up TPM Encryption Recovery Key.• FQXSFIO0008M: An intra-board UPI dynamic link width reduction has been detected on the linkbetween processor [arg1] port [arg2] and processor [arg3] port [arg4].Severity: WarningParameters:[arg1]: Socket number, 1-based [arg2]: Port Number [arg3]: Socket number, 1-based [arg4]: Port NumberUser Action:Complete the following steps:1. Power off the system and remove A/C power.2. Restore A/C power and power on the system.3. If the problem persists, collect Service Data logs and contact Lenovo Support.Note: The solution for this error may involve a system board replacement. If TPM encryption hasbeen enabled, back up TPM Encryption Recovery Key.• FQXSFIO0009M: An inter-board UPI dynamic link width reduction has been detected on the linkbetween processor [arg1] port [arg2] and processor [arg3] port [arg4].Severity: WarningParameters:148 ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Messages and Codes Reference