Lenovo ThinkSystem SD650 Manual

Also see for 5468: Setup guide Quick start

Severity: InfoUser Action:Information only; no action is required.• FQXSFPW0001L: CMOS has been cleared.Severity: WarningUser Action:Complete the following steps:1. If the CMOS clear was user initiated this event can be safely ignored and no further action is required.2. If the system was recently installed, moved, or serviced, make sure the battery is properly seated.3. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to thiserror.4. If the problem persists, collect Service Data logs and contact Lenovo Support.Note: The solution for this error may involve a system board replacement. If TPM encryption hasbeen enabled, back up TPM Encryption Recovery Key.• FQXSFSM0002N: Boot Permission denied by Management Module: System Halted.Severity: WarningUser Action:Complete the following steps:1. AC cycle the system.2. Check XCC logs,and make sure the PSU installation follows support guide line.3. Review power policies and system configuration settings in the XCC GUI.4. If the problem persists, collect Service Data logs and contact Lenovo Support.• FQXSFSM0003N: Timed Out waiting on boot permission from Management Module: SystemHalted.Severity: WarningUser Action:Complete the following steps:1. AC cycle the system.2. Check XCC logs,and make sure the PSU installation follows support guide line.3. Review power policies and system configuration settings in the XCC GUI.4. If the problem persists, collect Service Data logs and contact Lenovo Support.• FQXSFSM0004M: An XCC communication failure has occurred.Severity: WarningUser Action:Complete the following steps:1. AC cycle the system.2. Make sure XCC and UEFI FW are operating with same compatible level.3. Check Lenovo Support site for an applicable service bulletin or firmware update that applies to thiserror.Chapter 3. UEFI events 181