Alert Category: System - OtherSNMP Trap ID: 22CIM Prefix: IMM CIM ID: 0028User Action:1. If there was no operating-system error, complete the following steps until the problem is solved:2. Reconfigure the watchdog timer to a higher value.3. Make sure that the IMM Ethernet-over-USB interface is enabled.4. Reinstall the RNDIS or cdc_ether device driver for the operating system.5. Disable the watchdog.6. If there was an operating-system error, check the integrity of the installed operating system.• FQXSPOS4002I: Watchdog [arg1] Failed to Capture Screen.This message is for the use case where an operating system error has occurred and the screen capturefailed.Severity: ErrorServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22CIM Prefix: IMM CIM ID: 0029User Action:Important: Some cluster solutions require specific code levels or coordinated code updates. If the deviceis part of a cluster solution, verify that the latest level of code is supported for the cluster solution beforeyou update the code. Complete the following steps until the problem is solved:1. Reconfigure the watchdog timer to a higher value.2. Make sure that the XCC Ethernet over USB interface is enabled.3. Reinstall the RNDIS or cdc_ether device driver for the operating system.4. Disable the watchdog.5. Check the integrity of the installed operating system.6. Update the XCC firmware.• FQXSPOS4003I: Platform Watchdog Timer expired for [arg1].An implementation has detected an OS Loader Watchdog Timer ExpiredSeverity: ErrorServiceable: NoAutomatically notify Support: NoAlert Category: System - Loader timeoutSNMP Trap ID: 26CIM Prefix: IMM CIM ID: 0060User Action:Complete the following steps until the problem is solved:1. Reconfigure the watchdog timer to a higher value.2. Make sure that the XCC Ethernet-over-USB interface is enabled.3. Reinstall the RNDIS or cdc_ether device driver for the operating system.Chapter 2. XClarity Controller events 73