Lenovo ThinkSystem SD650 Manual

Also see for 5468: Setup guide Quick start

Information only; no action is required.• FQXPMEM0004I: Launching diagnostic programSeverity: InfoUser Action:Information only; no action is required.• FQXPMEM0005I: boot diagnostic program successSeverity: InfoUser Action:Information only; no action is required.• FQXPMEM0006M: Unable to locate diagnostic firmware imageSeverity: ErrorUser Action:1. Restart BMC via supported method and reboot the system.2. Perform AC reset or virtual reseat.Note: When performing AC reset, after powering off AC, wait several seconds before powering onAC. After AC power is restored, power on the host system.3. If the problem persists, contact technical support.• FQXPMEM0007M: Diagnostic image cannot be launched as "Console Redirection" is enabledSeverity: ErrorUser Action:1. Disable “Configure Console Redirection” in UEFI Setup by following below steps: - Go to F1 Setup ->System Settings -> Devices and I/O Ports-> Console Redirection Settings -> - Select "ConsoleRedirection" - Change the setting to “Disable” and save - Next reboot the system.2. Perform AC reset or virtual reseat.Note: When performing AC reset, after powering off AC, wait several seconds before powering onAC. After AC power is restored, power on the host system.3. If the problem persists, contact technical support.• FQXPMEM0008M: Diagnostic image cannot be launched as the image may be corruptSeverity: ErrorUser Action:1. Restart BMC via supported method and reboot the system.2. Perform AC reset or virtual reseat.Note: When performing AC reset, after powering off AC, wait several seconds before powering onAC. After AC power is restored, power on the host system.3. Reflash the LXPM.4. If the problem persists, contact technical support.• FQXPMEM0009M: Unexpected error occurChapter 4. XClarity Provisioning Manager events 193