This message is for the use case when an implementation has detected an Invalid/Unsupported Firmware/Software Version.Severity: ErrorServiceable: YesAutomatically notify Support: NoAlert Category: Critical - OtherSNMP Trap ID: 50CIM Prefix: PLAT CIM ID: 0446User Action:Reflash or update XCC firmware• FQXSPUP4000I: Please ensure that the Management Controller [arg1] is flashed with the correctfirmware. The Management Controller is unable to match its firmware to the server.This message is for the use case where a Management Controller firmware version does not match theserver.Severity: ErrorServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22CIM Prefix: IMM CIM ID: 0031User Action:Update the XCC firmware to a version that the server supports. Important: Some cluster solutions requirespecific code levels or coordinated code updates. If the device is part of a cluster solution, verify that thelatest level of code is supported for the cluster solution before you update the code.• FQXSPUP4001I: Flash of [arg1] from [arg2] succeeded for user [arg3] .This message is for the use case where a user has successfully flashed the firmware component (MC MainApplication, MC Boot ROM, BIOS, Diagnostics, System Power Backplane, Remote Expansion EnclosurePower Backplane, Integrated System Management).Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22CIM Prefix: IMM CIM ID: 0035User Action:Information only; no action is required• FQXSPUP4002I: Flash of [arg1] from [arg2] failed for user [arg3].This message is for the use case where a user has not flashed the firmware component from the interfaceand IP address due to a failure.Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22CIM Prefix: IMM CIM ID: 0036Chapter 2. XClarity Controller events 133