Lenovo ThinkSystem SD650 Manual

Also see for 5468: Setup guide Quick start

Severity: WarningParameters:[arg1]: Socket number, 1-based [arg2]: CoreNumber [arg3]: McBankNumber [arg4]: McaStatus [arg5]:McaAddress [arg6]: McaMiscUser Action:Complete the following steps:1. Perform a virtual reseat or AC cycle the server.2. If the problem persists, collect Service Data logs and contact Lenovo Support.• FQXSFPU4033F: TPM Firmware recovery is in progress. Please DO NOT power off or reset system.Severity: WarningUser Action:Information only; no action is required.Note: The system will not respond to power off signal (FQXSFPU4034I) while TPM firmware recovery inprogress.• FQXSFPU4034I: TPM Firmware recovery is finished, rebooting system to take effect.Severity: InfoUser Action:Information only; no action is required.• FQXSFPU4035M: TPM Firmware recovery failed. TPM chip may be damaged.Severity: WarningUser Action:Complete the following steps:1. Reboot the system.2. If the error recurs TPM related features will not work.3. If the problem persists, collect Service Data logs and contact Lenovo Support.Note: The solution for this error may involve a system board replacement. If TPM encryption hasbeen enabled, back up TPM Encryption Recovery Key.• FQXSFPU4038I: TPM Firmware recovery successful.Severity: InfoUser Action:Information only; no action is required.• FQXSFPU4040M: TPM selftest has failed.Severity: WarningUser Action:Complete the following steps:1. Reboot the system.2. If the error recurs TPM related features will not work.3. If the problem persists, collect Service Data logs and contact Lenovo Support.Chapter 3. UEFI events 177