Lenovo ThinkSystem SD650 Manual

Also see for 5468: Setup guide Quick start

3. Clone the image over and retry the operation.4. Perform AC reset or virtual reseat.Note: When performing AC reset, after powering off AC, wait several seconds before powering onAC. After AC power is restored, power on the host system.5. If the problem persists, contact technical support.• FQXPMCL0005I: Start to install OS.Severity: InfoUser Action:Information only; no action is required.• FQXPMCL0005K: Current System Boot Mode is Legacy. OS Clone only support UEFI Mode.Severity: WarningUser Action:1. Change Boot mode to UEFI mode (UEFI Setup -> Boot Manager -> Boot Modes -> System BootMode and select UEFI Mode.)2. Clone the image over and retry the operation.• FQXPMCL0030K: Failed to export raid config.Severity: WarningUser Action:1. Check the following Lenovo support site for information on supported RAID adapters. http://www.lenovo.com/us/en/serverproven/index.shtml2. Ensure RAID adapter, LXPM, and UEFI firmware are at the latest levels.3. Ensure the state of the RAID adapter and disk drives are normal.4. Verify proper physical connection of the disk drive, SAS expander (if applicable) and RAID adapter.5. Reboot the machine and retry the export of the RAID configuration.6. If the problem persists, contact technical support.• FQXPMCL0031I: Export raid config successfully.Severity: InfoUser Action:Information only; no action is required.• FQXPMCL0032K: Failed to import raid config.Severity: WarningUser Action:1. Check the following Lenovo support site for information on supported RAID adapters. http://www.lenovo.com/us/en/serverproven/index.shtml2. Ensure RAID adapter, LXPM, and UEFI firmware are at the latest levels.3. Ensure the state of RAID adapter and disk drives are healthy.4. Ensure good physical connection between the disk drives and RAID adapter.5. Ensure the platform and RAID config is identical to original configuration.190 ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Messages and Codes Reference