Lenovo ThinkSystem SD650 Manual

Also see for 5468: Setup guide Quick start

Information only; no action is required• FQXSPPW2008I: [PowerSupplyElementName] has been turned on.This message is for the use case when an implementation has detected a Power Unit that has beenEnabled.Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: System - Power OnSNMP Trap ID: 24CIM Prefix: PLAT CIM ID: 0107User Action:Information only; no action is required• FQXSPPW2031I: Numeric sensor [NumericSensorElementName] going low (lower non-critical) hasdeasserted.This message is for the use case when an implementation has detected a Lower Non-critical sensor goinglow has deasserted.Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: Warning - VoltageSNMP Trap ID: 13CIM Prefix: PLAT CIM ID: 0477User Action:Information only; no action is required• FQXSPPW2035I: Numeric sensor [NumericSensorElementName] going low (lower critical) hasdeasserted.This message is for the use case when an implementation has detected a Lower Critical sensor going lowhas deasserted.Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: Critical - VoltageSNMP Trap ID: 1CIM Prefix: PLAT CIM ID: 0481User Action:Information only; no action is required• FQXSPPW2047I: Numeric sensor [NumericSensorElementName] going high (upper critical) hasdeasserted.This message is for the use case when an implementation has detected an Upper Critical sensor goinghigh has deasserted.Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: Critical - Voltage96 ThinkSystem SD650 Dual Node DWC Tray and NeXtScale n1200 DWC Enclosure Messages and Codes Reference