Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22CIM Prefix: IMM CIM ID: 0109User Action:Information only; no action is required• FQXSPBR4006I: Management Controller [arg1]: Configuration restoration from a file by user [arg2]completed from [arg3] at IP address [arg4].This message is for the use case where a user restores a Management Controller configuration from a fileand it completes.Severity: InfoServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22CIM Prefix: IMM CIM ID: 0136User Action:Information only; no action is required• FQXSPBR4007I: Management Controller [arg1]: Configuration restoration from a file by user [arg2]failed to complete from [arg3] at IP address [arg4].This message is for the use case where a user restores a Management Controller configuration from a fileand the restoration fails to complete.Severity: ErrorServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22CIM Prefix: IMM CIM ID: 0137User Action:Complete the following steps until the problem is solved:1. Turn off the server and disconnect it from the power source. You must disconnect the server from ACpower cycle to reset the XCC.2. After 45 seconds, reconnect the server to the power source and turn on the server.3. Retry the operation.• FQXSPBR4008I: Management Controller [arg1]: Configuration restoration from a file by user [arg2]failed to start from [arg3] at IP address [arg4].This message is for the use case where a user restores a Management Controller configuration from a fileand the restoration fails to start.Severity: ErrorServiceable: NoAutomatically notify Support: NoAlert Category: System - OtherSNMP Trap ID: 22Chapter 2. XClarity Controller events 27