Screen 5-8COPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 11 TROUBLESHOOTING11-2518/9ItemF-POT-SWF-POT-DF-HUM-SWF-HUM-DDescriptionEnter ‘1’ if transfer/separation faults occur becauseof a fault in the sensor.Use it as a temporary remedy until replacement ofthe potential sensor.Use it together with ‘F-POT-SW’ (0 changed to 1).0: if image ratio of originals (text) is low1: if image ratio of originals (photo) is high2: not used usually, but re-transfer (white spot at 50mm along leading edge) occurs.The degree of separation current is highest at ‘0’and lowest at ‘2’.Enter ‘1’ if the environment sensor is faulty. (Controlis with reference to the input in ‘F-HUM-D’ insteadof the output of the humidity sensor.)Use it as a temporary remedy until replacement ofthe environment sensor.Enter an approximate humidity of the site (between30% and 99%).RemarksFactory default : 35
