2. Removing the Holding Tray from the Copier1) Open the front cover.2) Remove the fixing/feeding front cover.3) Slide the holding tray assembly to the front and out of the copier.3. Removing the Holding Tray Re-Pick Up Assembly1) Slide the holding tray assembly to the front and out of the copier.2) Remove the screw e (1 each), and remove the inlet assembly front upper cover qand the inlet assembly rear cover w; then, remove the two screws t and disconnectthe two connectors y to remove the sided guide plate r.Figure 5-8723) Remove the three mounting screws u (front).Figure 5-873 (front)uuq wertyCOPYRIGHT © 1997 CANON INC. CANON NP6350/NP6251 REV. 0 JULY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)CHAPTER 5 PICK-UP/FEEDING SYSTEM5-102
