Canon JX500 User Manual

Also see for FAX JX200: Manual Easy Setup instructions User guide User guide Service manual

Contents

Canon JX500 User Manual Manual pdf 77 page image

73TroubleshootingENGLISH The Printout Contains Blurred or Smudged InkGeneral Problems The Fax has no Power The Fax will not Print Reports Nothing Appears on the LCDCause ActionThe paper you are using may not besupported by the fax.Make sure you are using the recommended paper (see page 16).You may be printing on the wrong sideof the paper.Some papers have a “right” side for printing. If the print quality is not as clear asyou would like it to be, try turning the paper over and printing on the other side.Cause ActionThe power cord may not be plugged insecurely.Check that the power cord is plugged securely into the fax and into the walloutlet (see the Easy Setup Instructions). If the fax is plugged into a power strip,make sure the power strip is plugged in and turned on.The power cord may not be supplyingpower.Check the power cord by substituting with another.Cause ActionThe FINE Cartridge may need to bereplaced.Determine if the problem is with the FINE Cartridge and replace if necessary(see page 56).Cause ActionThe power cord may not be plugged insecurely.Check that the power cord is plugged securely into the fax and into the walloutlet (see the Easy Setup Instructions). If the fax is plugged into a power strip,make sure the power strip is plugged in and turned on. If the LCD remainsblank, unplug the fax, wait five seconds, then plug it in again.The LCD/LED may be in the PowerSaver mode.Press any button on the Operation Panel except for [ON/OFF] to restore thedisplay.