55Settings and Activity ReportsENGLISH Coded Speed Dialing ListLists the numbers and names registered under coded speed dialing codes. User’s Data ListLists the current settings of the fax and the registered sender information. List of Documents in MemoryLists the documents currently stored in the fax’s memory (see page 36). TX (Transmission) ReportNormally the fax does not print an activity report for transmitting, but you can set the fax to printan activity report every time you send a document. See on page 50.You can set the fax to print an activity report only when an error occurs during transmitting. See on page 50. RX (Reception) ReportNormally the fax does not print an activity report for receiving, but you can set the fax to print anactivity report every time you receive a document. See on page 50.You can set the fax to print an activity report only when an error occurs during receiving. See on page 50. Multi TX (Transmission) ReportLists the result of a sequential broadcasting.If you set the fax to print a and then use sequential broadcasting, a MULTI TXREPORT will be printed instead of a TX (Transmission) REPORT. See onpage 50.NoteFAX-JX500/JX300 models:Faxes or messages stored in the memory are backed up automatically if the power is tuned off orfails. If however, the data cannot be retried when the power is tuned on again, a memory clearreport is printed automatically.FAX-JX200/JX201 models:A memory clear report is printed automatically when power is restored after a power failure. See“Memory Clear Report” on page 74.
