|
47Using TAM Mode (FAX-JX500/JX300 only)ENGLISH7 Press [Stop].Setting ends and the fax returns to standby mode. Setting PIN ENTRYIf you set setting to , you must enter a password to use the forwardingfeature (see page 47).1 Follow steps 1 to 4 on page 46.2 Use []] or [_] to select , then press [Start]. The LCD displays NUMBER>.3 Use []] or [_] to select , then press [Start]. The LCD displays.4 Use []] or [_] to select , then press [Start].5 Press [Stop].Setting ends and the fax returns to standby mode.When a Forwarded Call is ReceivedWhen is set to , telephone messages recorded when the fax is set to will be automatically forwarded to a registered forwarding number.1 A call is received at the forwarding number.2 When you answer the phone you will hear your forwarding message.3 Press [#] while the forwarding message is playing.If you have not set a forwarding message, press [#] when you hear the tone.4 Enter your password when you hear the beeps.z When is set to (see page 47), step 4 is not required.z If you enter an invalid password, you will hear an error tone. If you enter two invalidpasswords consecutively, the call will be disconnected.5 Any new telephone messages will be played.6 When playback ends, it will be possible to use the remote control features.For the remote control features, see page 43.7 Hang up the Handset when you have finished.
|
