|
46 Using TAM Mode (FAX-JX500/JX300 only)ENGLISHForwarding Telephone MessagesThis feature allows you to automatically forward telephone messages, recorded when the fax is setto , to a registered forwarding number.You can use remote control to access the forwarding number and listen to your telephonemessages. Setting the Forwarding Number1 Press [Menu].2 Use []] or [_] to select , then press [Start]. The LCDdisplays .3 Use []] or [_] to select , then press [Start]. The LCD displays.4 Use []] or [_] to select , then press [Start]. The LCD displays.5 Use []] or [_] to select , then press [Start] twice. The LCD displays .6 Use the numeric buttons to enter the forwarding number, then press [Start].A maximum of 40 digits can be entered.7 Press [Stop].Setting ends and the fax returns to standby mode. Setting the Number of Redial Times1 Follow steps 1 to 4 on page 46.2 Use []] or [_] to select , then press [Start]. The LCD displays NUMBER>.3 Use []] or [_] to select , then press [Start]. The LCD displays.4 Use []] or [_] to select , then press [Start] twice. The LCD displays<2TIMES>.5 Use the numeric buttons, or []] or [_] to enter the number of redial times, thenpress [Start] twice. The LCD displays <2MIN.>.6 Use the numeric buttons, or []] or [_] to enter the redial interval, then press[Start].Notez You must register a forwarding number and set before you can use this feature. Remotecontrol cannot be used to set this feature unless a forwarding number has been registered.z If you set to when a forwarding message has not been recorded, you willhear a tone instead of a forwarding message when telephone messages are forwarded.
|
