21Sending FaxesENGLISH3 Use []] or [_] to select , then press [Start]. The LCDdisplays .4 Use []] or [_] to adjust the scanning contrast, then press [Start].You can select , or .5 Press [Stop].Setting ends and the fax returns to standby mode.Automatic Dialing Sending a Document Using One-Touch Speed Dialing or Coded SpeedDialing NumbersTo use this feature you must first register numbers for one-touch speed dialing (see page 13) orcoded speed dialing (see page 14).1 Load the document face up into the Document Tray.See “Loading Documents and Paper” on page 16.You can set the scanning resolution and the contrast (see page 20).2 Press the one-touch speed dialing button under which the number you wish to faxis registered.-or-Press [Coded] and enter the appropriate two-digit coded speed dialing code.The registered name and number appear.If you make a mistake, press [Stop]. Then press the correct one-touch speed dialing button orpress [Coded] and re-enter the code.3 Press [Start].The fax begins sending.-or-After about 10 seconds of no operation panel input, the fax starts sending automatically.01=CANON01=CANON
