Canon JX500 User Manual

Also see for FAX JX200: Manual Easy Setup instructions User guide User guide Service manual

Contents

Canon JX500 User Manual Manual pdf 23 page image

19Sending FaxesENGLISHSending FaxesSending DocumentsBefore you send a document, see “Documents Requirements” on page 15, and “Loading Documentsand Paper” on page 16. Direct Sending1 Load the document face up into the Document Tray.See “Loading Documents and Paper” on page 16.You can set the scanning resolution and contrast (see page 20).2 Dial the receiving party’s fax number.Use one of the dialing methods described in this chapter.3 Press [Start].The fax begins sending. Manual SendingIf you would like to first speak with the person you are sending the document to, use manualsending.1 Load the document face up into the Document Tray.See “Loading Documents” on page 16.You can set the scanning resolution and contrast (see page 20).2 Pick up the Handset or press [Hook] and dial the receiving party’s fax number.Use one of the dialing methods* described in this chapter.Notez If paper jams, see “Troubleshooting” on page 66.z You can send up to 20 A4-size (10 legal-size) pages at a time (based on the Canon FAX StandardChart No.1, standard resolution). You cannot add pages while the fax is sending.z The fax stores the document temporally in memory when sending a document, however, when memoryis full, it will send the document as it scans the document without storing document in memory.Notez If an error occurs during sending, the fax beeps intermittently for a few seconds and an errormessage appears on the LCD. If this happens, correct the problem and then press [Stop], thentry sending the document again. See “LCD Messages” on page 75.z The fax automatically redials if the receiving party does not answer or if the line is busy. (Youcan specify the number of times it redials; see on page 51.)TEL= 3456xxxxTEL= 3456xxxx