40 Using TAM Mode (FAX-JX500/JX300 only)ENGLISH3 Use []] or [_] to select , then press [Start] twice. The LCDdisplays <60 SECONDS>.4 Use []] or [_] to select the recording time, then press [Start].The recording time can be set to 0, 60, 120 or 240 seconds.5 Press [Stop].Setting ends and the fax returns to standby mode. Setting TAM MONITOR allows you to screen all incoming calls.1 Press [Menu].2 Use []] or [_] to select , then press [Start]. The LCDdisplays .3 Use []] or [_] to select , then press [Start]. The LCD displays.4 Use []] or [_] to select , then press [Start]. The LCD displays.5 Use []] or [_] to select , then press [Start].6 Press [Stop].Setting ends and the fax returns to standby mode. Setting TOLL SAVERSetting allows you to check whether you have any new messages when youcall from a remote location. When is set to and there are new messages,the fax will answer after the second ring. If there are no new messages the fax will ring five timesbefore answering.1 Press [Menu].2 Use []] or [_] to select , then press [Start]. The LCDdisplays .3 Use []] or [_] to select , then press [Start]. The LCD displays.NoteWhen the recording time is set to 0, the alternative outgoing message is played. If an alternativeoutgoing message has not been recorded, the outgoing message is played. In this case, there willbe no beep after the message is played and the caller will not be able to leave a message.NoteTo use this feature, (see page 50) must be set to a setting other than 0. If is set to 0, you will not be able to hear any incoming messages as they arebeing recorded.
