39Using TAM Mode (FAX-JX500/JX300 only)ENGLISH7 Hang up the Handset and press [Stop].The fax returns to standby mode.Setting TAM MODESetting allows you to receive telephone messages (ICM) and fax transmissions whilethe fax is unattended. When you cancel , any new telephone messages will be playedautomatically.1 Press [TAM] to set .z When you set , the TAM Lamp lights up and the outgoing message is played.z When you cancel , the TAM Lamp switches off. If you have any newtelephone messages, the messages are played automatically.z To cancel , press [TAM] again. Setting the Recording Time for a Telephone Message1 Press [Menu].2 Use []] or [_] to select , then press [Start]. The LCDdisplays .NoteYou cannot delete the . To record a new outgoing message, repeatsteps 1 to 7. The old outgoing message will be automatically deleted when you record your newmessage.Notez is displayed on the LCD when no outgoing message has been recorded. You mustrecord an outgoing message before you can set (see page 38).z A maximum of 55 messages, including an outgoing message, alternative message, voicememos, Fax/Tel message and forwarding message, with a total maximum recording time of 30minutes can be recorded. You can set a maximum recording time of 240 seconds for eachtelephone message (see page 40).z The number of messages or total recording time may be reduced if there are many faxes storedin memory.z If you have any new telephone messages, the TAM Lamp blinks and the number of messagesappears on the LCD.z The day and time when the telephone message was recorded, the number of telephonemessages and the number of the message being played (ICM No.) are displayed whenever amessage is played.NoteWhen the fax is set to and has been set to (see page 51), will be activated if the fax rings 15 times and the call is not answered(only when an outgoing message has been recorded). When the call is disconnected, the faxreturns to .15:00 :00
