E6582175Q-617Main and control circuit terminalsThis diagram shows an example of wiring of the main and control circuit (in case of sink logic).Standard connection diagram – SINK (Negative) (common: CC)Main circuit power supplyBraking resistor (Option)P0 PA/+ PB PC/-3ph-200-240V class: three-phase 200-240V-50/60Hz1ph-200-240V class: single-phase 200-240V-50/60Hz3ph-380-500V class: three-phase 200-240V-50/60HzSinglephasepowersupplyMCCBDC reactor (DCL)*2 (option)*1R/L1S/L2T/L3Protective functionactivation outputLow-speedsignal outputMCCB(2P)R/L1S/L2/NControl powersupply*5VF-S15 ControlcircuitFLAFLBFLCOperation panelSW1 *6SINK SOURCEPLC RS485connectorSW2VIBPTCS4S3FM CC VIC VIB VIA PPRYRCMeter1mA(or 0(4)-20mA/0-10V)External potentiometer (1k-10kΩ)(or voltage signal between VIA and CC: 0-10V)FRRESS1S2S3CCForward run commandReverse run commandResetPreset-speed command 1Preset-speed command 2Preset-speed command 3CommonSpeed reachSignal outputNoisefilter Power circuitMotorU/T1V/T2W/T3 MCurrent signal: 4(0)-20mAVoltage signal: 0-+10V(or -10-+10V)*3*4*4STO+SUFrequencymeter(ammeter)Ry*1: The T/L3 terminal is not provided forsingle-phase models.Use the R/L1 and S/L2/N terminals asinput terminals.*2: The inverter is supplied with the PO andthe PA/+ terminals shorted by means ofa shorting bar.Before installing the DC reactor (DCL),remove the bar.*3: When using the OUT output terminal insink logic mode, short the NO and CCterminals.*4: When VIA or VIB terminal is used aslogic input terminal, refer to section7.2.1.*5: To supply control power from anexternal power supply for backing up thecontrol power supplied from the inverter,an optional control power backup device(CPS002Z) is required. In such a case,the backup device is used at the sametime with the internal power supply ofthe inverter.The optional control power backup unitcan be used with both 240V and 500Vmodels.*6: Set the slide switch SW1 to SINK side.Refer to page B-11,12 for details.Default setting is PLC side.*7: When STO terminal is used ascompliance with safety standards, referto Safety function manual (E6581860).*7P24OUTNOCC
