E6582175F-156: CommunicationoptionFrequencies are set by commands from a communication option. Refer to each Instruction Manual of option.: Terminal VICA frequency command is set by means of external analog signals.(VIC terminal: 0 (4) - 20mAdc) Refer to section 3.2.2 and 7.3: Pulse train inputA frequency command is set by means of external pulse train signals.(S2 terminal: 10pps - 2kpps) Refer to section 6.10.514: sro Frequencies are set by sro parameter. Refer to section 5.7.● The control input terminal in which the following functions are set is always valid regardless of the setting of and . Reset (valid only for tripping) Standby External input tripping stop command Coast stop command terminal● To make changes in the command mode selection and the frequency setting mode selection 1, first stop the inverter temporarily.(Can be changed while in operation when is set to .)● Priority commands from communications or terminal blocks are given priority over . Preset-speed operation: Set to (Terminal block operation): Valid in all setting values. Input terminal settingsAssign the following functions to the input terminal to allow switching of the frequency command by turningthe terminal ON/OFF.Input terminal function ON OFF48 Forced local from communication Enabled during communicationLocal (Setting of , ) Communication106 Frequency setting mode terminalblock Terminal block (VIA) enabled setting of Each of the following numbers (49, 107) are reverse signals.
