576. Move the cross pointer on the screen to the startingpoint for the area by pressing the A, B, D or C but-ton, then press the SET button.1 +AREA SET/ERASE:PRESS[SET] AT CORNER7. Move the cross pointer on the screen to the endingpoint for the area by pressing the A, B, D or C but-ton, then press the SET button to determine the rectan-gular detecting area.1+AREA SET/ERASE:PRESS[SET] AT CORNERFour detecting areas can be set on the screen.To assign another detecting area, repeat the abovesteps 6 and 7.8. To delete the area, move the cursor to the rectangle tobe delete on the screen, then press the SET UP/ESCbutton.9. To return to the previous table, press the SET UP/ESCbutton.10. Repeat the above steps 4 to 9 to set the detector func-tion for other cameras.11. Press the SET UP/ESC button to return to the previousALARM SETUP menu. Alarm Mode on the MultiscreenMonitorThis item lets you select the mode for displaying an alarmon the Multiscreen Monitor.1. Move the cursor to the ALARM MODE MULTI OUTPUTin the ALARM SETUP menu by pressing the D or Cbutton.2. Select either ON or OFF by pressing the + or - but-ton.SPOT: The camera image that has activated the alarmis displayed in single spot mode.OFF: Ignores alarm activation and continues to displaythe images in the mode selected previously.The factory default setting is SPOT. Alarm Mode on the Spot MonitorThis item lets you select the mode for displaying an alarmon the Spot Monitor.1. Move the cursor to the ALARM MODE SPOT OUTPUT inthe ALARM SETUP menu by pressing the D or C but-ton.2. Select either ON or OFF by pressing the+ or - button.SPOT: The camera image that has activated the alarmis displayed in single spot mode.OFF: Ignores alarm activation and continues to displaythe images in the mode selected previously.The factory default setting is SPOT.