Panasonic WJ-HD500 Operating Instructions Manual

Also see for WJHD500 - DIGITAL DISC RECORDE: Operating instructions Instructions Service manual

Contents

Panasonic WJ-HD500 Operating Instructions Manual Manual pdf 26 page image

275. Select the ALL password (5-digit) by pressing theNumeric buttons (1 - 10).Refer to the password setup in the SYSTEM SETUPmenu for further details.The factory default setting is 12345.• To select "0" for numeric input, press the numeric 10button.• Entering an input will automatically check the pass-word.If the password is not correct, "PASSWORDERROR!" is displayed on the monitor screen andthe display returns to step 3.To enter the password again, repeat procedures 4and 5.• To quit entering the password, press the SETUP/ESC button.6. If the password is correct, the instructions shown belowappear in the lower-left corner of the menu.FORMAT MENUMAIN 1:30GB 2:30GBEXT5 1:30GB 2:30GB 3:30GB 4:30GBEXT4 1:ADD 2:ADD 3:ADD 4:ADDEXT3 1:- 2:- 3:- 4:-EXT2 1:- 2:- 3:- 4:-EXT1 1:- 2:- 3:- 4:-EXT0 1:- 2:- 3:- 4:-EXT DVD:-1DISK ALL ALL MIRRORRESTARTSELECT ITEM AND PRESS [SET] KEY7. Move the cursor to “ALL MIRROR” on the table bypressing the A, B, D or C button, then press the SETbutton. The ALL MIRROR FORMAT menu will appear onthe monitor.ALL MIRROR FORMATMAIN 1:30GB 2:30GBEXT5 1:30GB 2:30GB 3:30GB 4:30GBEXT4 1:* 2:* 3:ADD 4:ADDEXT3 1:LOST 2:LOST 3:LOST 4:LOSTEXT2 1:LOST 2:LOST 3:LOST 4:LOSTEXT1 1:- 2:- 3:- 4:-EXT0 1:- 2:- 3:- 4:-EXT DVD:OKEXECUTE? YES NOSELECT YES/NO AND PRESS [SET] KEY8. Select “YES” in the menu by pressing the A or B but-ton, then press the SET button to start formatting.9. When the formatting is completed, "FORMAT DONE!"appears in the lower-center of the menu.Normal camera images will appear on the monitor afterfive seconds.FORMAT MENUMAIN 1:30GB 2:30GBEXT5 1:30GB 2:30GB 3:30GB 4:30GBEXT4 1:* 2:* 3:ADD 4:ADDEXT3 1:LOST 2:LOST 3:LOST 4:LOSTEXT2 1:LOST 2:LOST 3:LOST 4:LOSTEXT1 1:- 2:- 3:- 4:-EXT0 1:- 2:- 3:- 4:-EXT DVD:OK1DISK ALL ALL MIRRORRESTARTSELECT YES/NO AND PRESS [SET] KEYTo deactivate the mirror function:• Select “MIRROR RELEASE” in the menu by pressingthe A, B, D or C button, then press the SET buttonduring the step 7 procedure.When the mirror function is activated, the “MIRRORRELEASE” is displayed in the menu as shown below.• All procedures are similar to setting the mirror function.