Section 7: SCPI command reference Series 2280 Precision Measurement DC Power Supplies Reference Manual7-102 077085501 / February 2015:SYSTem:EVENtlog:SAVEThis command saves the event log to a file on a USB flash drive.Type Affected by Where saved Default valueCommand only Not applicable Not applicable Not applicableUsage:SYSTem:EVENtlog:SAVE A string that holds the name of the file to be savedDetailsThis command saves all event log entries since the last clear command to a USB flash drive.You must insert the USB flash drive before sending this command.The extension .csv is automatically added to the file name.Example:SYST:EVEN:SAVE "error_log" Saves the error events in the event log to a fileon the USB flash drive named error_log.csv.Also see:SYSTem:ERRor:CLEar (on page 7-100):SYSTem:GPIB:ADDRessThis command sets the GPIBaddress..TypeAffected by Where saved Default valueCommand and query Not applicable Nonvolatile memory 5Usage:SYSTem:GPIB:ADDRess :SYSTem:GPIB:ADDRess? The GPIB address of the instrument (1 to 30)DetailsThe address can be set to any address value from 1 to 30. However, the address must be unique inthe system. It cannot conflict with an address that is assigned to another instrument or to the GPIBcontroller.A new GPIB address takes effect when the command to change it is processed. If there are responsemessages in the output queue when this command is processed, they must be read at the newaddress.If command messages are being queued (sent before this command has executed), the new settingsmay take effect in the middle of a subsequent command message, so care should be exercised whensetting this attribute from the GPIB interface.You should allow ample time for the command to be processed before attempting to communicatewith the instrument again. After sending this command, make sure to use the new address tocommunicate with the instrument.*RST does not affect the GPIB address.
