Section 7: SCPI command reference Series 2280 Precision Measurement DC Power Supplies Reference Manual7-86 077085501 / February 2015DetailsThis command sets or reads the contents of the enable register of the Measurement InstrumentSummary Event Register (MISER).When one of these bits is set and the corresponding bit in the MISER set, bit 1 in the MeasurementInstrument Event Register is set.When sending binary, preface with #b. When sending hexadecimal, preface with #h. Nopreface is needed when sending decimal values.Example:STAT:MEAS:INST:ISUM:ENAB #b0000100000000001 Sets the output and reading overflow bitsof the Measurement InstrumentSummary Enable register using a binaryvalue.You could also send the decimal value2049 or the hexadecimal value: #h801.Also seeMeasurement Instrument Summary Event Register (on page D-16):STATus:MEASurement:INSTrument:ISUMmary:CONDition?This command reads the Measurement Instrument Summary Condition Register of the status model.Type Affected by Where saved Default valueQuery only Not applicable Not applicable Not applicableUsage:STATus:MEASurement:INSTrument:ISUMmary:CONDition?DetailsThis command reads the contents of the Measurement Instrument Summary Condition Register.For details about interpreting the value of a register, see Measurement Instrument Summary EventRegister (on page D-16).Example:STAT:MEAS:INST:ISUM:COND? Returns the contents of the MeasurementInstrument Summary Condition Register ofthe status model.Also seeNone
