Section 7: SCPI command reference Series 2280 Precision Measurement DC Power Supplies Reference Manual7-48 077085501 / February 2015DetailsThis command sets the falling delay so that output will not turn off until the delay has elapsed. Thiscommand affects on-to-off transitions, including the operation::OUTPut:STATe ONExample:OUTP:DELay:FALLing 1 Set the falling delay time to 1 s.Also see:OUTPut:DELay:RISing (on page 7-48):OUTPut[:STATe] (on page 7-51):OUTPut:DELay:RISingThis command specifies the delay time that the instrument waits before turning on the specified output.Type Affected by Where saved Default valueCommand and query Recall settingsInstrument resetPower cycleSave settings 0Usage:OUTPut:DELay:RISing :OUTPut:DELay:RISing ,:OUTPut:DELay:RISing?:OUTPut:DELay:RISing? :OUTPut:DELay:RISing? DEFault:OUTPut:DELay:RISing? DEFault,:OUTPut:DELay:RISing? MINimum:OUTPut:DELay:RISing? MINimum,:OUTPut:DELay:RISing? MAXimum:OUTPut:DELay:RISing? MAXimum, Delay rising time: 0 to 10 s with the resolution of 0.001 s. The channel number: Channel 1: CH1 Channel 2: CH2The default value is CH1DetailsThis command sets the rising delay so that output will not turn on until the delay has elapsed. Thiscommand affects off-to-on transitions, including the operation::OUTPut:STATe ONExample:OUTP:DELay:RISing 1 Set the rising delay time to 1 s.
