Series 2280 Precision Measurement DC Power Supplies Reference Manual Section 3: Functions and features077085501 / February 2015 3-31Configuring a listTo set up a list from the front panel, you select options from the Source List screen.To configure a list on the front panel1. Press the Menu key.2. Under Source, highlight the List icon using either the navigation control or the soft keys. Pressthe ENTER key. The Source List screen is displayed.Figure 77: Source List screen3. Select the button next to List and press the ENTER key. The List Location screen is displayed.4. Select a list location where you want to save the list and press the ENTER key. The Series 2280supports up to 9 list locations. You can also import a predefined list from external USB flashdriver. For details, refer to Importing a list from an external USB flash drive (on page 3-33).5. Use Insert or Copy button to increase the points of the list. For details, refer to Inserting orcopying points from the front panel (on page 3-32). Use Delete button to delete the points. Fordetails, refer to Deleting points from the front panel (on page 3-32).You can use Insert button to add one point with default settings before each specified point. Thedefault settings are: 0.000 V, 0.100 A, 0.100 s. You can also use Copy button to copy theselected settings of the point and insert a new point with the same settings before each point.For an empty list, you can add the first point by selecting point 1 and press the ENTER key. The firstpoint is configured to the default settings.6. After adding points to the list, select the Voltage box, Current box or Dwell box in the specifiedpoint row. Press the ENTER key. The editing window is displayed. You can use the numericalkeys or the navigation control to change the value.7. Select the Save button to store the list in memory location.8. Enter a name for the list on the displayed keypad and press ENTER.