Series 2280 Precision Measurement DC Power Supplies Reference Manual Section 7: SCPI command reference077085501 / February 2015 7-87:STATus:OPERation[:EVENt]?This command reads and clears the Operation Event Register of the status model.Type Affected by Where saved Default valueQuery only Not applicable Not applicable Not applicableUsage:STATus:OPERation[:EVENt]?DetailsThis command reads the Operation Event Register of the status model and then clears the register.The instrument returns a decimal value that corresponds to the binary-weighted sum of all bits set inthe register. For details, see Operation Event Register (on page D-9)Also seeNone:STATus:OPERation:ENABleThis command sets or reads the contents of the Operation Event Enable Register of the status model.Type Affected by Where saved Default valueCommand and query Power cycle Not applicable 0Usage:STATus:OPERation:ENABle :STATus:OPERation:ENABle? The status of the operation status registerDetailsThis command sets or reads the contents of the enable register of the Operation Event Register.When one of these bits is set and the corresponding bit in the Operation Event Register is set, theOSB bit in the Status Byte Register is set.When sending binary values, preface with #b. When sending hexadecimal values, preface with #h. No preface is needed when sending decimal values.Example:STAT:OPER:ENAB #b0010000000000000 Sets the Operation Status EnableRegister using a binary value.You could also send the decimal value8192 or the hexadecimal value #h2000.Also seeOperation Event Register (on page D-9)
